Keep a small slider where the finger left it while the light fades towards it (0.2.71)

A light group's lamps fade, Home Assistant reports every step, and the tile's slider followed each one: after a drag it
jumped back to the old value and crept up. The Tile now holds the sent value (brightness, fan percent, volume) until
Home Assistant reports within 3 % of it, reports the entity off, refuses, or reports once and stays quiet for 1.5 s;
never longer than 8 s, and without any report the hold ends with the wait. A cover's position slider keeps following
the blind. Firmware 0.2.60; host checks 17/17 on both boards.

Co-Authored-By: Claude Fable 5.1 <noreply@anthropic.com>

packages/cyd.yaml

@@ -18,7 +18,7 @@
 ############################################################
 
 substitutions:
-  SCREEN_FIRMWARE_VERSION: "0.2.59"
+  SCREEN_FIRMWARE_VERSION: "0.2.60"
   # A tap survives a finger that drifts up to this far (320 px over 58 mm: 1 cm); further is a swipe.
   TOUCH_MOVE_LIMIT_PX: "56"
   # Shortest contact that counts as a tap; a resistive panel bounces, a capacitive one does not.

packages/guition.yaml

@@ -3,7 +3,7 @@
 # Source profile for packages/guition.yaml (tools/generate_packages.py); see docs/GUITION.md.
 # A screen gets its tiles from the ESP Screen Manager add-on while it runs. The CYD is its own profile.
 substitutions:
-  SCREEN_FIRMWARE_VERSION: "0.2.59"
+  SCREEN_FIRMWARE_VERSION: "0.2.60"
   # 0: no drift limit; LVGL decides, releasing inside the tile is a tap, leaving it is not
   # (like iOS). The CYD keeps a limit because its resistive panel jumps.
   TOUCH_MOVE_LIMIT_PX: "0"