Add touch_probe and touch_reset actions to the Elecrow for a diagnosis over the API (0.2.97, firmware 0.2.83)

packages/boards/elecrow-crowpanel7.yaml

@@ -385,6 +385,7 @@ smart_display:
   partitions: 4mb_wide_slots
   # The GT911 out of reset through the V3.0's PCA9557 before the driver runs (elecrow_touch_reset.h, firmware 0.2.82).
   elecrow_touch_reset:
+    id: touch_reset
     i2c_id: touch_bus
     address: 0x18
 
@@ -410,6 +411,23 @@ api:
     - action: ui_snapshot
       then:
         - script.execute: capture_ui_snapshot
+    # The touch bus at a glance (firmware 0.2.83): the PCA9557's registers and whether a GT911 answers at 0x5D or 0x14.
+    - action: touch_probe
+      then:
+        - lambda: 'id(touch_reset).probe();'
+    # Elecrow's reset sequence with values of one's own, then the probe: the expander's configuration register during
+    # the reset (0 = every pin an output), its output register while the reset is held and after the release, the two
+    # waits in ms, and the configuration afterwards. Elecrow's own values: 0, 0, 1, 20, 100, 2.
+    - action: touch_reset
+      variables:
+        config: int
+        low: int
+        high: int
+        hold_ms: int
+        wait_ms: int
+        final_config: int
+      then:
+        - lambda: 'id(touch_reset).reset(config, low, high, hold_ms, wait_ms, final_config);'
     # A camera full screen from Home Assistant (firmware 0.2.57+), as a tap on its tile opens it; an empty entity closes
     # it. Only a camera on the screen's tiles or in a recent alert gets an image from ESP Screens.
     - action: preview_camera