One rule ends a Sleep: a tap, Wake or an alert. The Auto standby switch
cleared sleep_requested when Home Assistant turned standby off, while
ESP Screens and the settings page on the screen did not; now only
wake_display clears the flag, and apply_screen_settings still wakes a
screen the standby time dimmed.
dim_display no longer checks anything itself (the interval checks Auto
standby, the Sleep button sets the flag). It dims, then runs go_home with
"also on standby" on, otherwise closes the settings page and every card
through close_cards. Before, it copied half of go_home and hid the four
YAML overlays itself, so a runtime detail card stayed open under a dimmed
screen. close_cards is now the one runtime_tiles::dismiss() call: the
fallback and the widget.hide actions after its return ran for nothing.
The backlight light becomes internal. Home Assistant could change it, but
the minute tick put the level back, and switching it off darkened the
screen without standby. The brightness numbers and Wake/Sleep replace it.
A dead clock-label branch from the manual profile leaves
apply_screen_settings.
Checked with 209 Python and 14 C++ tests, host builds of both boards over
the native API, and ESP32 builds of both Easy profiles. Firmware 0.2.46.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
Every screen gets two template buttons, Wake and Sleep, for automations
(button.press on button.<screen>_wake / _sleep). Wake does what a tap does:
a dimmed screen runs wake_display, a screen that is on only restarts the
standby count. Sleep dims right away through dim_display, also with Auto
standby off, and closes an alert that is up (reported as remote); it is
ignored during a touch calibration.
A new non-restored flag, sleep_requested, keeps that standby in place:
dim_display dims with standby off, and apply_screen_settings, which runs
every minute, no longer wakes such a screen. wake_display clears it (a tap,
Wake, an alert), and so does the Auto standby switch when it really turns
standby off. Nothing is saved, so the buttons cost no flash writes and may
run on every motion.
The Claude skill, README, add-on docs and RELEASING describe both buttons.
Checked on host builds of both boards over the native API, 24 checks each
(timer, Sleep with Auto standby off across a minute tick, alert,
calibration), and with ESP32 builds of both Easy profiles (+336 B RAM).
Firmware 0.2.45.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
Max Gramser