The 2 ms reset of ESPHome's expander support (0.2.81) left the chip silent: "Calibration error" with the PCA9557
answering at 0x18. A component of smart_display's (elecrow_touch_reset.h, setup priority 700: after the I2C bus,
before the GT911 driver) writes the expander as Elecrow's V3.0 ESPHome example does: every pin an output and low,
20 ms, the reset released, 100 ms, the interrupt line back to an input. The driver's reset and interrupt pins are gone.
A unit's touch never answered: "touchscreen is marked FAILED: Calibration error" at setup, the GT911 still in reset
behind the PCA9557 (I2C 0x18) of the V3.0 board. The board file declares the expander as ESPHome's pca9554 (the same
register map) and hands the GT911 driver its reset (IO0) and interrupt (IO1) pins on it, so the driver runs Elecrow's
own sequence: reset low with the interrupt line low, reset high, 56 ms, address 0x5D. A V2.0 without the expander boots
its GT911 by the pull-up as before. The bus is scanned at boot for the log.
The GT911 of the CrowPanel 7.0" sits on GPIO 19 and 20, the ESP32-S3's USB pins. Firmware 0.2.79 freed them once, in a
static constructor; the Wi-Fi PHY library then kept the USB PHY on (CONFIG_ESP_PHY_ENABLE_USB, on by default on an
ESP32-S3) and the touch went quiet once Wi-Fi came up. The board file turns that option off, frees the pins again in
BOOT_TOUCH after Wi-Fi started, and a one-second watchdog frees them whenever anything takes them, with a log line.
A board file for the Elecrow CrowPanel 7.0" (DIS08070H, ESP32-S3-WROOM-1-N4R8): 800x480 through mipi_rgb, GT911 on the
ESP32-S3's USB pins (elecrow_usb_phy.h frees them, behind a flag only this board sets), the Guition's vertical sizes
across a wider page, no rotation. Its 4 MB of flash take the CYD's budget: a partition table of the component's
(smart_display: partitions: 4mb_wide_slots, 1,984 KB slots), the icon fonts at 2 bits a pixel and the TLS client only
bring the firmware to 1,865,440 bytes, 91.8 % of a slot, with camera images kept. docs/ELECROW.md has the numbers and
the trade.
The add-on reads a large board's name from the type sensor's value, the editor offers the board under New screen and
draws the wide preview, tools/check.sh builds it with the budget, render_topbar and capture_ui take the panel's size.
Firmware 0.2.79; the CYD image is unchanged (1,633,760 bytes).
This fork builds from gittea.trippedonmy.name/Xandrossian/homeassistant_espscreen: the packages, the fonts, the
component and the add-on repository point there instead of GitHub.
Xandrossian